系統識別號 | U0002-2208201313191400 |
---|---|
DOI | 10.6846/TKU.2013.00893 |
論文名稱(中文) | LED多晶模組熱性能量測分析 |
論文名稱(英文) | Thermal Performance Study in Multi-Chip Light Emitting Diode |
第三語言論文名稱 | |
校院名稱 | 淡江大學 |
系所名稱(中文) | 機械與機電工程學系碩士班 |
系所名稱(英文) | Department of Mechanical and Electro-Mechanical Engineering |
外國學位學校名稱 | |
外國學位學院名稱 | |
外國學位研究所名稱 | |
學年度 | 101 |
學期 | 2 |
出版年 | 102 |
研究生(中文) | 林冠閔 |
研究生(英文) | Kuan-Min Lin |
學號 | 600370778 |
學位類別 | 碩士 |
語言別 | 繁體中文 |
第二語言別 | |
口試日期 | 2013-07-11 |
論文頁數 | 49頁 |
口試委員 |
指導教授
-
康尚文(swkang@mail.tku.edu.tw)
委員 - 王建評 委員 - 蔡孟昌 |
關鍵字(中) |
發光二極體 熱阻 結點溫度 溫度敏感係數 |
關鍵字(英) |
LED Thermal Resistance Junction Temperature TSP |
第三語言關鍵字 | |
學科別分類 | |
中文摘要 |
發光二極體(Lighting Emitting Diode; LED)具有耗電量小、使用壽命長、更加環保、顏色豐富以及高亮度之優勢,在近年來有逐步取代傳統光源之趨勢,並廣泛應用在發光面板上,但是其仍然有散熱方面的問題,為此,探討LED之散熱研究為目前最重要的課題之一。本實驗使用T3Ster熱性能量測系統,建立LED溫度敏感係數(Temperature Sensitive Parameter; TSP)曲線並使用其後處理程式T3SterMaster做結構方程式轉換得知LED構裝之熱阻比熱容圖,介而推估每一層熱阻大小。 本論文使用元件大小為1.4cm×1.4cm,厚度0.2cm,單顆晶粒大小為0.12cm×0.12cm×0.015cm,欲研究探討LED多晶模組(2 Chips LED與4 Chips LED)分別以操作電流100mA、350mA、500mA、700mA在不同間隔距離(0.25cm、0.45cm、0.74cm、1.02cm)以及晶粒串並聯方式之情況下,其之熱性能表現。 其結果顯示,串並聯之連接在2 Chips LED與4 Chips LED實驗中,其接點溫度間只有些微的差異;而在操作電流越大時,熱阻也相對越大,但是隨著晶粒間距離的增加,熱阻則不完全會隨之減少;考量LED多晶模組之熱性能優化時需要考量到晶粒間的距離以及模組幾何尺寸的相互影響。 |
英文摘要 |
Lighting Emitting Diode (LED), which has various advantages, such as less power consumption, long lifespan, green environment, variegated colors, high brightness. In these days LED not only has replaced traditional light sources step by step but also has widespread used at lighting plates. But it also has some weakness like heat dissipation. Therefore, thermal management of LEDs modules is one of the most important issues. In this study, using T3Ster measurement system, Temperature Sensitive Parameter (TSP) curves of the LEDs modules were attained then transform transient data to cumulative structure function graphics by the T3SterMaster software. A series of 2 chips LED and 4 chips LED with 0.25cm, 0.45cm, 0.74cm, 1.02cm four different distances have been packaged in an 1.4cm x 1.4cm x 0.2cm aluminum plate and tested their thermal resistance. The dimension of the single In-GaN blue LED chip is 0.12cm x 0.12cm x 0.015cm. To investigate influence of the electricity on the LEDs modules, tests were conducted under parallel and series circuit respectively, with 100mA, 350mA, 500mA, and 700mA four different control currents. It was shown that a slight variation of junction temperature between parallel and series circuit tests. Increasing the control current will increase the thermal resistance of LEDs modules. In addition to chip distance, result also showed that size of aluminum plate and boundary condition might have consequences for thermal resistance. |
第三語言摘要 | |
論文目次 |
誌謝 I 中文摘要 III 英文摘要 IV 目錄 VI 圖目錄 VIII 表目錄 XI 符號表 XII 第一章 緒論 1 1.1 研究背景與動機 1 1.2 文獻回顧 1 第二章 實驗原理 6 2.1 LED簡介 6 2.2 熱傳遞原理 6 2.2.1 熱傳導 7 2.2.2 熱對流 7 2.3 熱阻定義 8 2.3.1 半導體熱阻定義 8 2.4 量測原理 9 2.4.1 溫度敏感係數曲線 10 第三章 實驗設備與方法 11 3.1 實驗設備 11 3.1.1 T3Ster 13 3.1.2 Power Booster及Thermostat系統 14 3.1.3 電源供應器 14 3.1.4 紅外線量測系統 15 3.2 實驗模型 15 3.3 實驗方法與步驟 22 3.3.1 可控制變因 23 3.3.2 實驗步驟與數據處理 24 第四章 實驗結果與討論 35 4.1 串並聯探討 35 4.2 熱性能表現探討 39 4.3 多晶模組熱阻預測探討 44 第五章 總結與未來展望 46 5.1 總結 46 5.2 未來展望 47 參考文獻 48 圖 1 各層間尺寸參數[6] 2 圖 2 因子反應影響圖[6] 3 圖 3 LED於不同環境溫度下壽命與光輸出[7] 4 圖 4 LED溫度與其壽命影響[7] 4 圖 5 實驗設備 12 圖 6 可控溫平台 12 圖 7 紅外線熱像儀 15 圖 8 模組尺寸圖 16 圖 9 待測LED模組 17 圖 10 距離1-1(2 Chips LED) 18 圖 11 距離2-2(2 Chips LED) 18 圖 12 距離3-3(2 Chips LED) 19 圖 13 距離4-4(2 Chips LED) 19 圖 14 距離1-1(4 Chips LED) 20 圖 15 距離2-2(4 Chips LED) 20 圖 16 距離3-3(4 Chips LED) 21 圖 17 距離4-4(4 Chips LED) 21 圖 18 LED結構之熱阻-熱容圖 23 圖 19 量測之TSP曲線圖 25 圖 20 程式T3Ster Booster Plug-in Setup 26 圖 21 T3SterMaster之Sensitivity輸入圖 27 圖 22 實驗之Delay Time和Time Limit測試圖 27 圖 23 結構方程式微分圖 29 圖 24 結構方程式微分斜率趨近於無限大示意圖 29 圖 25 結構方程式分界圖 30 圖 26 本文之LED熱阻結構分布圖 31 圖 27 區隔鋁基板熱阻以及接觸空隙之熱阻之依據 31 圖 28 T3Ster暫態熱阻取得之原理(1) 32 圖 29 T3Ster暫態熱阻取得之原理(2) 33 圖 30 紅外線熱像儀校正圖 34 圖 31 2 Chips LED在不同電流、距離、連接下的結點溫度表現 35 圖 32 4 Chips LED在不同電流、距離、連接下的結點溫度表現 37 圖 33 2 Chips LED在不同操作電流及距離下的熱阻表現 39 圖 34 2 Chips LED在不同操作電流及距離下的結點溫度表現 40 圖 35 2 Chips LED結點溫度與紅外線比較圖 40 圖 36 4 Chips LED在不同操作電流及距離下的熱阻表現 41 圖 37 4 Chips LED在不同操作電流及距離下的結點溫度表現 42 圖 38 4 Chips LED結點溫度與紅外線比較圖 42 圖 39 4 Chips紅外線熱影像圖 43 圖 40 不同電流下之多晶LED模組預測趨勢圖 45 圖 41 700mA多晶LED模組預測趨勢圖 45 表1 2 Chips LED之Tj相對誤差百分比 36 表2 4 Chips LED之Tj相對誤差百分比 38 |
參考文獻 |
[1] James Petroski, “Thermal Challenges Facing New Generation Light Emitting Diodes (LED) for Lighting Applications”, Solid State Light II, Proc. of SPIE, Vol. 4776, pp. 215-222. 2002. [2] Frank Wall, Paul S. Martin, Gerard Harbers” High Power LED Package Requirements”, Third International Conference on Solid State Lighting, Proc. of SPIE, Vol. 5187, pp.85-92, 2004 [3] OIDA, “Light Emitting Diodes (LEDs) for General Illumination”, An OIDA Technology Roadmap Update 2002 [4] Park, J., Shin, M., Lee, C. C., “Measurement if temperature profiles on visible light-emitting diodes by use of a nematic liquid crystal and an infrared laser,” Optics Letters, Vol. 29, No. 22, p1656-2658. 2004. [5] Hwang, W. J., Lee, T. H., Kim, L., and Shin, M. W., “Determination of junction temperature and thermal resistance in the GaN-based LEDs using direct temperature measurement,” phys. Stat. sol. (c) 1, No. 10,2429-2432. 2004. [6] James Petroski, “Spacing of High-Brightness LEDs on Metal Substrate PCB's for Proper Thermal Performance” Inter-Society Conference on Thermal Phenomena, IEEE, pp. 507-514. 2004. [7] Nadarajah Narendran and Yimin Gu, ”Life of LED-Based White Light Sources”, Journal of Display Technology, IEEE/OSA, Vol. 1, No. 1, 2005 [8] 王焜雄, LED構裝溫度量測與熱傳分析, 清華大學動力機械工程學系, 碩士論文, 2008 [9] 曾俊瑜, LED發光二極體暫態熱阻量測分析, 淡江大學機械與機電工程學系, 碩士論文, 2012 [10] F. Kreith, and M.S. Bohn, “Principles of Heat Transfer”, 6th Edition, Brooks/Cole, Pacific Grove, California, 2001。 [11] EIA/JEDEC Standard, “Integrated Circuits Thermal Measurement Method-Electrical Test Method (Single Semiconductor Device),” EIA/JESD51-1,1995. [12] EIA/JEDEC Standard, “Transient Dual Interface Test Method for the Measurement of the Thermal Resistance Junction to Case of Semiconductor Devices with Heat Flow Trough a Single Path,” EIA/JESD51-14,2010. [13] T3Ster, Thermal Transient Tester Technical Information |
論文全文使用權限 |
如有問題,歡迎洽詢!
圖書館數位資訊組 (02)2621-5656 轉 2487 或 來信